Skip to main content

PBH02 - two point harness

Our entry level fall arrest safety harness with one rear ‘dorsal’ and one front ‘sternum’ attachment point.

Lightweight, easy to don with four points of adjustment to ensure a better fit. Available with carbon steel, stainless steel or plastic coated pressed steel dielectric fittings, this harness is suitable for fall arrest and work restraint as well as work positioning on inclined surfaces via a rope and grab.

Product Features

  • Attachment Points Rear D fall arrest attachment point (Dorsal)
    Front D fall arrest attachment point (Sternum)
  • Fittings Carbon steel, black powder coated
    Stainless steel (optional)
    Dielectric fittings (optional)
  • Webbing Polyester webbing, water repellent & UV resistant
  • Elasticated Webbing 45mm Elasticated Webbing (10% Elasticity)
  • Padding Optional detachable shoulder yoke - thermo formed
  • User Weight 150kg Maximum [Including tools and equipment]

Standards

  • EN 361
TDS-04-PBH01-IS5-3

Attachment Point

The front and rear “D” rings are safe to connect to any EN compliant fall protection system.

TDS-04-PBH01-IS5-4

Reinforced Webbing

Potential stress points are reinforced for an extra level of safety and durability.

TDS-04-PBH01-IS5-5

Label Pouch

All individual Harness information is kept securely inside the label pouch for easy reference.

TDS-04-PBH01-IS5-6

Trapezoidal Buckles

Angled buckles ensure that harness webbing follows the contours of the body for a more comfortable and secure fit.

TDS-04-PBH01-IS5-7

Fall Arrest Indicator

Fall arrest indicating tabs allow the user to easily and confidently determine if the harness has been subjected to fall forces.

TDS-04-PBH01-IS5-8

End Stops

Webbing ends are finished with a tactile, branded rubber end stop.

TDS-04-PBH01-IS5-9

Contrast Stitching

Contrast stitching is used for easy inspection, prior to donning.

Product Features

The PBH02 is designed to support the body and distribute the forces to prevent serious injury and keep the worker in a safe position ready for rescue in the event of a fall.

Certified fall arrest points are clearly marked with an A, the rear “D” should always be your primary anchorage, although front “D” connection is permitted but is primarily for work positioning.

For fall arrest the PBH02 must only be used in conjunction with an energy absorber or load limiting device with a maximum impact force 6kN.

When used for fall arrest a pre-determined rescue plan must be a part of your safe system of work.

Recommended minimum anchor strength – 12kN.

  • 1. 100% Polyester Webbing
  • 2. Sternum Fall Arrest Attachment
  • 3. Trapezoidal Buckles
  • 4. Dorsal Fall Arrest Attachment
  • 5. Back support and label pouch
  • 6. Fall Indicator Tabs
  • 7. Leg Loops
TDS-05-PBH02-IS6-17
1
2
3
4
5
6
7
Products: Vantage Back to: PBH02 two point harness

Thank you for your interest in PBH02

Please enter your email address to receive more information about PBH02.